SIGINTERRUPT(3-BSD) RISC/os Reference Manual SIGINTERRUPT(3-BSD)
NAME
siginterrupt - allow signals to interrupt system calls
SYNOPSIS
siginterrupt(sig, flag);
int sig, flag;
DESCRIPTION
siginterrupt is used to change the system call restart
behavior when a system call is interrupted by the specified
signal. If the flag is false (0), then system calls will be
restarted if they are interrupted by the specified signal
and no data has been transferred yet. System call restart
is the default behavior on 4.2 BSD.
If the flag is true (1), then restarting of system calls is
disabled. If a system call is interrupted by the specified
signal and no data has been transferred, the system call
will return -1 with errno set to EINTR. Interrupted system
calls that have started transferring data will return the
amount of data actually transferred. System call interrupt
is the signal behavior found on 4.1 BSD and AT&T System V
UNIX systems.
Note that the new 4.2 BSD signal handling semantics are not
altered in any other way. Most notably, signal handlers
always remain installed until explicitly changed by a subse-
quent sigvec(2) call, and the signal mask operates as docu-
mented in sigvec(2). Programs may switch between restart-
able and interruptible system call operation as often as
desired in the execution of a program.
Issuing a siginterrupt(3) call during the execution of a
signal handler will cause the new action to take place on
the next signal to be caught.
NOTES
This library routine uses an extension of the sigvec(2) sys-
tem call that is not available in 4.2BSD, hence it should
not be used if backward compatibility is needed.
RETURN VALUE
A 0 value indicates that the call succeeded. A -1 value
indicates that an invalid signal number has been supplied.
SEE ALSO
sigvec(2), sigblock(2), sigpause(2), sigsetmask(2).
Printed 1/15/91 Page 1