NAME

tran_reset − reset a SCSI bus or target

SYNOPSIS

#include <sys/scsi/scsi.h>

int prefixtran_reset(struct scsi_address ∗ap, int level);

INTERFACE LEVEL

Solaris architecture specific (Solaris DDI). 

ARGUMENTS

ap Pointer to the scsi_address(9S) structure. 

level The level of reset required. 

DESCRIPTION

The tran_reset() vector in the scsi_hba_tran(9S) structure must be initialized during the HBA driver’s attach(9E) to point to an HBA entry point to be called when a target driver calls scsi_reset(9F). 

tran_reset() must reset the SCSI bus or a SCSI target as specified by level.

level must be one of the following:

RESET_ALL reset the SCSI bus. 

RESET_TARGET reset the target specified by ap.

tran_reset should set the pkt_reason field of all outstanding packets in the transport layer associated with each target that was successfully reset to CMD_RESET and the pkt_statistics field must be OR’ed with either STAT_BUS_RESET or STAT_DEV_RESET.

The HBA driver should use a SCSI Bus Device Reset Message to reset a target device. 

Packets that are in the transport layer but not yet active on the bus should be returned with pkt_reason set to CMD_RESET, and pkt_statistics OR’ed with STAT_ABORTED.

RETURN VALUES

tran_reset() should return:

1 on success. 

0 on failure. 

SEE ALSO

attach(9E), ddi_dma_buf_setup(9F), scsi_hba_attach(9F), scsi_reset(9F), scsi_address(9S), scsi_hba_tran(9S)

Writing Device Drivers

NOTES

If pkt_reason already indicates that an earlier error had occurred for a particular pkt, tran_reset() should not overwrite pkt_reason with CMD_RESET. 

SunOS 5.5/SPARC  —  Last change: 30 Aug 1995