NAME

XmDialogShell − The DialogShell widget class

SYNOPSIS

#include <Xm/DialogS.h>

DESCRIPTION

Modal and modeless dialogs use DialogShell as the Shell parent.  DialogShell widgets cannot be iconified.  Instead, all secondary DialogShell widgets associated with an ApplicationShell widget are iconified and de-iconified as a group with the primary widget. 

The client indirectly manipulates DialogShell via the convenience interfaces during creation, and it can directly manipulate its BulletinBoard-derived child.  Much of the functionality of DialogShell assumes that its child is a BulletinBoard subclass, although it can potentially stand alone. 

Setting XmNheight, XmNwidth, or XmNborderWidth for either a DialogShell or its managed child usually sets that resource to the same value in both the parent and the child.  When an off-the-spot input method exists, the height and width of the shell may be greater than those of the managed child in order to accommodate the input method.  In this case setting XmNheight or XmNwidth for the shell does not necessarily set that resource to the same value in the managed child, and setting XmNheight or XmNwidth for the child does not necessarily set that resource to the same value in the shell. 

For the managed child of a DialogShell, regardless of the value of the shell’s XmNallowShellResize, setting XmNx or XmNy sets the corresponding resource of the parent but does not change the child’s position relative to the parent.  XtGetValues for the child’s XmNx or XmNy yields the value of the corresponding resource in the parent.  The x and y coordinates of the child’s upper left outside corner relative to the parent’s upper left inside corner are both zero minus the value of XmNborderWidth. 

Note that the Inter-Client Communication Conventions Manual allows a window manager to change or control the border width of a reparented top-level window. 

Classes

DialogShell inherits behavior and resources from Core, Composite, Shell, WMShell, VendorShell, and TransientShell classes. 

The class pointer is xmDialogShellWidgetClass. 

The class name is XmDialogShell. 

New Resources

DialogShell defines no new resources but overrides the XmNdeleteResponse resource in the VendorShell class. 

Inherited Resources

DialogShell inherits behavior and resources from the following superclasses.  For a complete description of each resource, refer to the man page for that superclass. 

The following table defines a set of widget resources used by the programmer to specify data.  The programmer can also set the resource values for the inherited classes to set attributes for this widget.  To reference a resource by name or by class in a .Xdefaults file, remove the XmN or XmC prefix and use the remaining letters.  To specify one of the defined values for a resource in a .Xdefaults file, remove the Xm prefix and use the remaining letters (in either lowercase or uppercase, but include any underscores between words).  The codes in the access column indicate if the given resource can be set at creation time (C), set by using XtSetValues (S), retrieved by using XtGetValues (G), or is not applicable (N/A). 

Translations

There are no translations for XmDialogShell. 

RELATED INFORMATION

Composite(3X), Core(3X), Shell(3X), TransientShell(3X), WMShell(3X), VendorShell(3X), and XmCreateDialogShell(3X).